Инженерный центр

EDID and EEPROM Configuration for Display Modules

Part of:

EDID and EEPROM configuration determines whether the host negotiates the correct mode, timing, and feature set at boot. In industrial displays, a bad descriptor is often indistinguishable from a hardware fault until the I2C data is read back and validated.

Industrial TFT LCD Connector Pinout Guide

Part of:

Connector pinout errors create expensive failures because they look like panel defects until the harness, grounding, and interface mapping are checked. The safe approach is to document every power, data, backlight, and control pin before layout is frozen.

Touch Controller Integration in Industrial HMI

Part of:

Touch integration in industrial HMI is mostly about noise control, timing, and how the controller reports coordinates under real field conditions. The important work is not the GUI layer, but the electrical and protocol boundaries around the panel.

MCU vs FPGA Display Interface Architecture

Part of:

MCU and FPGA display architectures solve different problems: one optimizes cost and control flow, the other isolates timing and parallelism. The right choice depends on refresh rate, interface complexity, and how much display logic must sit outside the main processor.

Display Subsystem Architecture for Industrial HMI Systems

System-level engineering guide for industrial HMI display subsystems—signal chain, PMIC integration, touch coexistence, EMI boundaries, and validation checklists for production-ready TFT LCD designs.